Once you have your call cut out and shaped, hewned out, and your rails crowned, your paddle shapped, crowned and drilled, and the screw put in so you can play your call, then it's time to start the Tuning. The tuning is mostly done by sanding the rails and knowing where and how much to sand them. Tuning takes time there is no fast way to do it, you PLAY YOUR CALL as you TUNE IT, because it only takes a couple of strokes with the sandpaper to ruin a call.
Part 1 is the easiest part of tuning, your just sand the inside of the rails flat to get all od the drilling marks off. Be carefull not to sand your rails to thin, keep your sanding block flat against the rail as you sand it. Yes it's all done by hand!!!
- Tuning part 1.jpg (36.2 KiB) Viewed 1337 times
Last edited by WillowRidgeCalls
on August 13th, 2013, 3:17 am, edited 1 time in total.